Toggle Nav
Sold Out - Here are alternatives
Loading...
This Triumph Herald 13-60 Convertible (1967) Diecast Model Car is Orange and has working wheels and also comes in a display case. It is made by Vanguards and is 1:43 scale (approx. 9cm / 3.5in long). Most initially expected the Herald to be phased out after the Triumph's new front-wheel drive 1300 saloon was launched in 1965 - but it continued to sell well - partly because it was cheaper and partly because it had built up a loyal following. Thus Triumph gave it a facelift in 1967 and created the 13/60 (1300cc engine - 60bhp) using an over-bored version of the previous 1147cc 12/50 engine. Its styling was also substantially - but very economically - updated by use of the Vitesse bonnet-pressing with single instead of twin headlights. In this form the saloon remained in production until replaced by the Toledo in 1970. However - the last convertible 13/60s - as modelled here - were built in September 1971. Limited edition of 1000 pieces worldwide complete with numbered certificate.

Diecast models are manufactured to various scales based on measurements taken from the actual vehicles. The rule to remember is the higher the scale number, the smaller the model!

So, 1:2 scale quite ltierally means it is 1/2 (half) the size and 1:4 scale means it is 1/4 (quarter) the size.  Here is a rough guide to the size of our models although this will vary depending on the size of the actual vehicle. Please note that the scale and size of models differs per department. Please refer to the individual product page to find out the estimated size of the actual model you would like to purchase.

Bikes

1:32 scale will be approximately 5cm long
1:24 scale will be approximately 8cm long
1:18 scale will be approximately 10-12cm long
1:12 scale will be approximately 14-18cm long
1:10 scale will be approximately 20-28cm long
1:6 scale will be approximately 30-38cm long

Cars

1:64 scale will be approximately 6cm long
1:43 scale will be approximately 10cm long
1:24 scale will be approximately 15-25cm long
1:18 scale will be approximately 20-30cm long
1:12 scale will be approximately 30-40cm long

Same marque by the same company
Same marque and scale model cars
Same marque model cars
Similar model cars
div